Well, all I had been doing was looking at it in the garage. But I did a bit more cutting and fitting lately. The sides of the floor pan went up and over and down the outside of the frame rails. There was a small outward formed edge, on the outer lower edge of the outer portion, that interfered with the lower edge of the body rocker. And, at the lower door opening, there was a bit of a angle that was resting on the outer top corner of the floor pan. So, I trimmed the edge of the floor pan so the body would sit as low as it could on the frame/floor pan. The steel tubes, that were glassed in, at the A-Pillar were rusted at the bottom. The door must have been previously mounted. The hinges were still on the doors. But the holes in the A-Pillars are filled with bondo. So I cut those out.